Insert only the number of battery cells that are intended to be used with the SB20x in the SB20x daughter board socket. Further, make sure to place the jumper that selects the correct number of cells - otherwise one of the battery cells will be shorted.
| Step | Action | Remark |
|---|---|---|
| 1 | Power Off SB200 | Remove Batteries |
| 2 | Insert SB201-? or SB202 | |
| 3 | Start PC SW | |
| 4 | Place Red Jumper correctly | Only one jumper |
| 5 | Power On SB200 | Check that a correct SB201/SB202 is shown in status bar |
| 6 | # of Cells LED should light up | |
| 7 | Insert battery / batteries | |
| 8 | Press HWB button | One minute charge is started |