Event Control

Name:
EVCTRL
Offset:
0x02 [ID-00000bc7]
Reset:
0x00
Access:
PAC Write-Protection, Enable-Protected
Bit76543210
INVEI1INVEI0EMPTYEO1EMPTYEO0STARTEI1STARTEI0
AccessR/WR/WR/WR/WR/WR/W
Reset000000

Bit 5 – INVEI1: Enable Inversion of DAC1 input event

Enable Inversion of DAC1 input event

This bit defines the edge detection of the input event for DAC1 (START1).

ValueDescription
0 Rising edge.
1 Falling edge.

Bit 4 – INVEI0: Enable Inversion Data Buffer Empty Event Output DAC0

Enable Inversion Data Buffer Empty Event Output DAC0

This bit defines the edge detection of the input event for DAC0 (START0).

ValueDescription
0 Rising edge.
1 Falling edge.

Bit 3 – EMPTYEO1: Data Buffer Empty Event Output DAC1

Data Buffer Empty Event Output DAC1

This bit indicates if the Data Buffer Empty Event output for DAC1 is enabled.

ValueDescription
0 Data Buffer Empty event is disabled.
1 Data Buffer Empty event is enabled.

Bit 2 – EMPTYEO0: Data Buffer Empty Event Output DAC0

Data Buffer Empty Event Output DAC0

This bit indicates if the Data Buffer Empty Event output for DAC0 is enabled.

ValueDescription
0 Data Buffer Empty event is disabled.
1 Data Buffer Empty event is enabled.

Bit 1 – STARTEI1: Start Conversion Event Input DAC1

Start Conversion Event Input DAC1

This bit indicates if the Start input event for DAC1 is enabled.

ValueDescription
0 A new conversion will not be triggered on any incoming event.
1 A new conversion will be triggered on any incoming event.

Bit 0 – STARTEI0: Start Conversion Event Input DAC0

Start Conversion Event Input DAC0

This bit indicates if the Start input event for DAC0 is enabled.

ValueDescription
0 A new conversion will not be triggered on any incoming event.
1 A new conversion will be triggered on any incoming event.