Features
- ATSAME54P20A
microcontroller
- One mechanical reset button
- One mechanical programmable
button
- One QTouch® PTC button
- One yellow user LED
- 256 Mb QSPI Flash
- ATECC508 CryptoAuthentication™ device
- AT24MAC402 serial EEPROM with EUI-48™ MAC address
- Ethernet
- RJ45 connector with built-in magnetics
- KSZ8091RNA PHY
- 10Base-T/100Base-TX IEE 802.3
compliant Ethernet transceiver
- SD/SDIO card connector
- Parallel Capture Controller header
(ArduCAM compatible)
- CAN connector
- Backup super capacitor
- 32.768 kHz crystal
- 12 MHz crystal
- USB interface, host, and device
- Three Xplained Pro extension
headers
- 10-pin Cortex® Debug Connector with
SWD
- 20-pin Cortex Debug + ETM Connector
with SWD and four bit trace
- Embedded Debugger
- Auto-ID for board
identification in Atmel Studio
- One yellow status LED
- One green board power
LED
- Symbolic debug of complex
data types including scope information
- Programming and debugging,
including power measurements
- Data Gateway Interface: SPI,
I2C, four GPIOs
- Virtual COM port (CDC)
- Embedded current measurement
circuitry (XAM)
- Measures power consumption of
the ATSAME54P20A and / or peripherals
- Measures current between 100
nA and 400 mA
- Current measurement data
shown in Microchip Data Visualizer
- USB powered
- Supported with application examples
in Atmel START