SMARTCARD Xplained Pro implements one Xplained Pro Standard Extension Header on page 6 marked with EXT in silkscreen. This header makes it possible to connect the board to any SMARTCARD supporting Xplained Pro MCU board. The pin-out definition for the extension header can be seen in Table 4-1, “SMARTCARD Xplained Pro Extension Header”.
Pin on EXT | Function | Description |
---|---|---|
1 | ID_DATA | Communication to the ID chip |
2 | GND | Ground |
3 | NC | |
4 | NC | |
5 | CARD_DETECT | Card Detect |
6 | NC | |
7 | GCLK | GCLK Signal |
8 | NC | |
9 | RESET | Card Reset (GPIO generated) |
10 | VCC_ENABLE | Card VCC Enable |
11 | NC | |
12 | NC | |
13 | XCK | USART Clock |
14 | I/O | USART Input/Output (Bidirectional) |
15 | NC | |
16 | NC | |
17 | NC | |
18 | NC | |
19 | GND | Ground |
20 | VCC_TARGET | Target supply voltage (3.3V) |