Interface Settings

The programming interfaces have different settings. Some interfaces have no settings at all, some interfaces settings are only available on some tools. This section will describe all settings, but they are not available for all tools and devices.

JTAG

If you have selected JTAG as the programming interface, clock speed, use external reset and daisy-chain setting may be available. This depends on the tool and device.



JTAG Clock

JTAG clock is the maximum speed the tool will try to clock the device at. The clock range is different for different tools and devices. If there are restrictions, they will be stated in a message below the clock slider.

Use external reset

If checked, the tool will pull the external reset line low when trying to connect to the device.

JTAG daisy-chain settings

Specify the JTAG daisy-chain settings relevant to the device to program.

Target is not part of a daisy-chain. Select this option when the target device is not part of a daisy-chain.

Daisy chain-Manual. Allows you to manually configure the JTAG daisy-chain in case you are programming in a system-on-board.

Daisy chain-Auto. Automatically detects the devices in the JTAG daisy-chain. Allows you to select the device in the JTAG daisy-chain. Auto-detection is supported only for SAM devices.



To accept the changes and configure the tool, press the Set button.

PDI

The PDI interface has only one setting – the PDI clock speed.



PDI Clock is the maximum speed the tool will try to clock the device at. The clock range is different for different tools and devices. If there are restrictions, they will be stated in a message below the clock slider.

To apply the changes and configure the tool, press the Set button.

The clock cannot be adjusted on all tools, so an empty Interface settings page will be presented.