Connect aWire using a 6-pin cable between the ISP/PDI connectors.
For routing cards RC36 revision 3, RC38 revision 4, RC40 revision
2 and older, use the following procedure:
- 1.Mount the routing and socket card, and
the target device. See the Socket System section on how to do this.
- 2.Connect a cable between Pin3 (TDO) on
the JTAG header on the blue area and Pin6 (Reset) on the JTAG header on the green area.
See the picture below.
- 3.Ensure that the VTARGET jumper is
mounted and that the voltage is within the operating range for the target device.
The pinout of the 10-pin JTAG header is shown below: