Hardware Setup for On-board Programming

  1. 1.Mount the appropriate cards and the target device. See the Socket System section on how to do this.
  2. 2.Connect a 6-wire cable between the two 6-pin ISP/PDI headers on the STK600. See the picture below.
  3. 3.Ensure that both the VTARGET and RESET jumpers are mounted.
  4. 4.Set VTARGET to 5.0V (5V is required for programming with TPI).
  5. 5.Set the clock selection switch to “INT” to disconnect the STK600 programmable clock source from TPICLK.


The pinout of the 6-pin ISP/PDI header when in TPI mode is shown below:



Parent topic: TPI Programming